Swing Gate Hinges

A full range of gate hardware, including hinges with bearings and adjustable height. Heavy duty hinges built to take the heavy loads demanded by automatic gates most with height and gap adjustment.

OTHER PAGES OF INTEREST IN THIS CATEGORY
Gate Stops

DOUBLE WING WELD ON ITALIAN BEARING HINGE

Heavy duty weld on hinge with double wing weld on points with ball bearing washer. Made in Italy.

HINGE120.180 - $16.40 each

ADJUSTABLE HINGE TOP SECTION

Heavy duty hinge with 90mm back plate. Adjusts for easy alignment Made in Italy. Requires bottom section (see below) or can be used both top and bottom.

ADJHINGETOP - $9.90 each

ADJUSTABLE HINGE BOTTOM SECTION

Bottom section for adjustable hinge (above). Two pieces weld to gate and post. Galvanised finish. Gate gap - 50mm

ADJHINGEBOT - $8.00 Both Pieces

TOP BEARING HINGE 50X50X3 SHS

Heavy duty weld on hinge designed for 50x50x3 mm SHS. Galvanised finish with adjuster for alignement. Suitable for very heavy wrought iron gates and as a top hinge for underground motors. Fully sealed bearings. Made in Italy. When used for wrought iron gates use bottom bearing hinge below.

TOPBEAR50MM - $107.70 each

BOTTOM BEARING HINGE 50x50x3 SHS

Heavy duty bottom bearing hinge for Top Bearing Hinge (above). Suits 50x50x3 RHS Steel

BOTBEAR50MM - $139.90 each

BIG WELD ON BEARING HINGE

The toughest hinge of the lot. A must for automatic gates. Weld on hinge with height adjuster. Ball bearing hinge with adjuster bolt and grease nipple.

BIGHINGE - $45.00 each.

180 DEGREE OPENING HINGE

The versatile hinge in our range. The 180 hinge will do exactly that, allow your gate to hinge a full 180 degrees. Comes complete with bearing and full sideways adjustment. Well built - will suit heavy gates.

180HINGE - $56.90 each.

MULTIFIT HINGE

The multifit hinge is designed for light weight pool and pedestrian gates. Simple to fit and self closing

MULTIFIT - $14.10 pair.

HOME - PRODUCT - ORDER - SITEMAP - DIY - CONTACT